UPDATED - Revision 2

• Added Flat head screwdriver features to the end of the tool.
  • The smaller tool is used to open the door on the bottom of the vacuum head.
  • The larger round tool on the side is used to remove the vacuum roller.
• Shortened the shaft a little. Using the clip to hold the tool, the tool stuck out past the bottom of the canister and it would catch on my leg while vacuuming. Shortened it to match the drum and it does not get caught as often. And this makes for a little less material. and a slightly faster print.

Revision 1
This is a remake of waleedk's Dyson Tool.
When I redrew it, I created a shorter curved part so it is a little less plastic and less support material when printing.
Tapered the end so it can be used as a screwdriver to remove the long plate on the vacuum head.
The taper angles from the top, so that the it will print flat with no supports on that end.
Added a hook at that end for cleaning out the groove that gets clogged in the vacuum head (behind the removable plate).
Matched the stem width so that it holds securely in my Dyson Cleaning Tool Clip design:
https://www.thingiverse.com/thing:3700076

Creality

Ender 3

No

Yes

.2

20