I needed to manage the wires on the underside of my Uplift standing desk, and I didn't want to use the included adhesive cable tie mounts. So I printed these wire management clips.

There are two sizes of clips:

• Smaller size that snaps onto the inner crossbar rail.
• Larger size that snaps onto the left and right crossbar ends.

The inner crossbar rail clip is mirror-symmetric, so it can attach in either direction.

The outer crossbar end clip is not symmetric. One side has a cutout that fits over a protrusion that runs the length of the outer crossbar. This cutout side should be oriented towards the outside of the desk.

Printed in PETG with 3 external perimeters, 0% infill, and zero top or bottom layers.