This is a tapestry needle, about 7 ½" long and ¼" wide, 

It was printed standing on end (the one with the hole) to preserve roundness; with brim, and supports on “everywhere” for the hole, it should only take an hour with all these settings on, but feel free to change the parameters based on how you see fit.

It was printed on an ender 3 max neo.

the first time it was printed the top got all squiggly (the table probably got bumped) but it turned out fine with a little sanding, the second time it was printed the room was vacated for fear of bumping the table and it turned out great. I will add a model where it starts tapering off higher up to maintain the thickness for longer, but until then, Happy Prints <3.