Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 4.5mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Green Transmission Distance: 2

PLA BambuLab Basic Yellow Transmission Distance: 6

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Silver Transmission Distance: 0.5

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 6 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #11 (0.96mm) swap to Green

At layer #19 (1.6mm) swap to Yellow

At layer #29 (2.4mm) swap to Black

At layer #34 (2.8mm) swap to Blue Gray

At layer #43 (3.52mm) swap to Silver

At layer #50 (4.08mm) swap to Jade White for the rest.