A simple stand for a stone egg or sphere. 3 sizes. .SCAD file included so you can adapt as required.

Printing:

I used 25% infill, no supports, using PLA+ (but I suspect you could use PLA or ABS without problems) on my Prusa i3.

!!UPDATE!! If the eggs tend to slide around then you could try roughening the top surface with sandpaper or a file. However, what I found best is a thin smear of silicon sealant ... let cure without an egg and you will find they become very stable :-)

Prusa

i3 MK3

No

No

200

25