Made in openscad this is a flip lock for an older hard bodied pop up camper. A friend had one that had several of these locking clips broken on. I took about an hour to make the OpenScad script and then fine tune and parametize it. If you need to make a different size then the STL provided, visit the customizer to make your version of the lock. This is designed to hold panels onto the side of a pop up camper in place once assembled. The lock swings down in front of the panel to keep it from coming out. A screw goes through the backside of the mounting panel to attach to rounded mount. These can be used in any location where a swing lock would come in handy.

Davinci 1.0a Repetier Customized

No

Yes

.40

50

I printed these at .30mm height at 50% infill with support material for the latch arm. The text was printed at the .5 setting in the list and is almost too small to be legible with a .4 tip as it tends to fill in the fine detail gaps in the lettering. If you print without text, you can flip the parts over and print them flat on the surface without using any supports. This will lead to a higher quality lock in the end.