Bracket to hold a ThermoPro TP50 Digital Hygrometer inside a filament dry box. Sized for #10 hardware. Includes "washers" that go on the outside of the box. Styled to go along with my filament box rod bracket.

Print instructions

The main bracket should print without supports (especially in PLA). I printed it without support in PETG (ColorFabb ngen) on an MK3S. The results were a little rough but the problems in bridging are hidden behind the hygrometer. Nothing special as far as tolerances so 0.4 or 0.6mm nozzle should be fine at just about any layer height.