This is an old design that  I imported from my prints on Thingiverse.

I needed to remove the top cap from the airspring on my Rockshox Sid.
This can be done with a cassette tool but mine has a centre pin to locate it on the shaft/cassette.
So I made a new tool for the top cap.

It has a 1/2" socket for a wrench.

I printed it in PLA with 4 outer perimters and it was strong enough to remove the top cap.
The top cap should be torqued to 12.4 Nm/110 in-lb

Category: Sport & Outdoors