A rather snug 2 part case for a Gotcha Generation with a keyring loop.

Note that by snug, I mean the band clasps had to be trimmed with flush cutters (which for mine was broken anyway). If your resin / filament has any degree of shrinkage or your tolerances aren't great bump up the scale on the body part - maybe 105% size

Top part slides into the body of the case once Gotcha has been slid in. Take note that the Gotcha button should be oriented down towards the rounded part of the screen cutout. There is also a cutout in the back to allow charging without disassembling the case and one at the base to allow pushing from the bottom to remove the Gotcha once installed.

Designed as a resin print but could be done with filament I'm sure with a bit of tweaking and clever supports.

Feel free to comment / offer suggestions.

Creality

HALOT ONE PRO

No

Yes

Any

100