Here is an easy to print and use extractor to remove cables from JST-XH (2.54 mm) connectors. Best way to print is like shown in thumbnail image. You might need to rotate object. Support is required for better dimension accuracy.

Can be printed with PRO PLA (3D870) or PETG. Both are flexible enough for this to work.

Layer height: 0.16 or 0.20 is ok

Perimeters: 3

Infill: 10%

Support: Yes (print same orientation as shown in picture)

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

0.16

Infill:

Filament: 3d-fuel PRO PLA

Notes:

Category: Electronics