This is a window mount for a Wyze V3 Cam. It is intended to smush the WyzeCam V3 camera lens/face flush against a window's glass (indoors), and thus to minimize any reflections that are added by the window glass. It cannot work unless the camera's built-in IR illumination and status light are both off. It does function as intended during daylight hours, even through double-pane window glass. That said, there is not enough light in the location where I placed it to get any useful image at all during the nighttime. I may try placing one of the V3 compatible Wyze spotlights adjacent to the V3 camera and see if that helps with illuminating the outside scene without causing issues. TBD

This enclosure is a modification and remix of a few different existing pieces. I used the https://www.thingiverse.com/thing:4693119 Wyze V3 Cover along with the https://www.thingiverse.com/thing:4821088 Wyze V3 Window Mount Back.
I would have used the main mount from the Holocron 88 design but I had some issues getting it sliced, so I likely repeated some of the same work they had done to create that piece. "Thank you!" to both Gartnix and Holocron for all their efforts!

The printed parts fit my V3 cam with zero issues.

Update:
I used some clear double sided gorilla tape to hold the window mount in place and so far it has not shifted a bit. Here is a link to the tape I used. https://www.amazon.com/Gorilla-6036002-Tough-Mounting-inches/dp/B07LFRN1K8

Qidi Tech 1

No

Yes

.3

White PLA was in the printer. I believe black would be a better choice. I used a black magic marker to blacken the area surrounding the camera lens hole to minimize reflections.