I love these little guys! The glue on the LED strips is not the best, so when I installed my 10mm wide strips I sketched up some little clips so the LEDs would be a little more secure.

I printed 21 of these in 12 minutes and they simply worked. Its a loop for a woodscrew and a bar. Simple yet effective.

Print instructions

I printed them in PETG, you may be able to get away with PLA, but the LEDs do get a little warm so the clips may creep after a while.

These are so small that infill is unlikely to matter, I used 10%
No support is necessary
Don't use a brim (they're so small that removing it would be a nightmare)
I used a 0.2mm layer height