Don't you hate it when you're at the office or home and the vent is too cold in your face? Or perhaps you want to redirect it somewhere that's a warmer corner of your room? You're in luck! This is a simple air conditioner ceiling vent redirector and or diffuser.

No glue or anything needed, works even with small printers and with low resolution and low quality. Fits most of them. Its design is to hook onto some of the ceiling vent blades and then allows you to attack corrugated-plastic boards that are cut to 10cm wide with a scissor. Any of the thinner ones will do. They take about 1 hour to print and you can use faster quality. The width of the air vent itself is the standard 55cm you find all over Asia in office buildings and homes.

Monoprice

Select Mini

No

No

Faster Poor Resolution is fine

10%