This is a remix of a design I found by Dudestroger on Cults as I really liked the design. With most MagSafe designs you can see the cable at the front and this didn't have that.

The design is nice and steady. Be aware though that there is no support shelf under the phone, so it relies on the MagSafe to hold it in place.With the phone case I use it didn't quite hold it strongly enough, so I added a circular magnet to the case made specifically for that reason. With no case, or an official MagSafe case it hold really well.

Hole for the charger is a really excellent fit. There are spaces for if you want to add little magnets to hold the charger more firmly but I found they weren't required.

The Apple logo is inset into the charger. Fitted perfectly on my printer but a friend who printed it downsized the logo to 99%. If fit is too tight either do that or simply do a tiny bit of filing around the edge of the logo.

Creality

Ender 3

No

Yes

0.2

50%

Only used supports for the top of the holes, might not have been required.

Used 50% infill but for weight rather than strength. 100% would probably be even better for weight.