I based this design off of owtcydur's Giant Squid model. I printed his and much preferred the feel of the joints in McGubeer's Cute Mini Octopus so I decided to make my own with the best of both; a giant squid with print in place joints.

This is an all in one print that fits on an Ender 3 or similar sized bed coiled up. It's pretty risky to print if you don't have good adhesion as it's 163 individual pieces, but I didn't have any issues, I just ran the first few layers a bit slower than I normally would and watched it to make sure it got off to a good start.

No

No

0.2

5-15