Here's something useful. Servo wires stick out the side and can be in the way. The back of most servo wires come out of the side which are obstructed in many applications.

This is the back of a MG995 servo with the wire coming out the back to resolve clearance issues.

There is a little insert to block the hole where the wire is inserted.

Printed on Creality ender 5plus.

0.2 layer height
PLA
Raft with supports for the screw hole platform which is slightly offset from the back of the part works.

This part was made in solidworks with a caliper to measure dimensions, it's not perfect but it works. I uploaded the solidworks part for you to edit if you have the software.

There is also a model of a MG995 servo in stl and solidworks file extensions for modeling purposes.
It is also not perfect but a good start.

Hope this helps with your robotics project and troubleshooting.

Creality

Ender-5 Plus

Yes

Yes

0.2

0.2 height or smaller for good fit.

Caliper and reverse modeling the part and adding the cutout for the wire on the back.