My sister had a commercial version on this ashtray/debowler, but she broke the spike in the middle so I made her a replacement. The original didn't have the cutouts for holding cigars/cigarettes/etc but I thought it was worth adding. The original also melted when she let some flowers burn in it about the same as mine burned when I didn't fully put out a tobacco cigarette in my PLA test print.

The one in the photo is ABS. I decided that a bit more noticeable stink factor, and higher melting/burning point, were worth more than my, or her apartment down. We both make candy so burning PLA/corn syrup/sugar are pretty normal for us.

If you choose to print this, use an appropriate material, and make sure you are able extinguish it quickly. I take no responsibility for your moment of dumb which causes a fire in this ashtray. That's all on you, farkin burnout.