Not sure where them heretics are? Need to do some purging but those tricky genestealers won't tell you were they are? Well you need an Auspex Scanner!

This prints as 1 single piece! so all you have to do is print it, and paint it! (if you want to)

***it is important to note that to get the best quality you will want to tilt the part 30 degrees back on the buildplate and then add a small support block on the base to hold it in place while it prints (just like in the photo). this prevents any support material from actually touching the features on the print, meaning it will look the best it can!

Check out my collection of Warhammer props!
https://cults3d.com/en/users/LanceGreene