This part uses the same basic geometry definition as Lofts1 (https://www.thingiverse.com/thing:3132672), but with a pentagon instead of a square and 5 Loft shapes instead of 4 to form a polar array. There is quite a large amount of filament used in this part due to the large number (5 x 5 = 25) of curved surfaces the comprise it. So If you decide to print this I suggest starting with a full or nearly full reel of filament.

This part printed in 31 1/3 hours using a print speed of 80 mm/sec and a layer height of 0.200 mm.