I learned that one of the tracking leds was on the bottom of the controller and based on how much it shone through the plastic in pictures i thought its likely obscured by the top lock in the original files. I cut out a section slightly bigger than the spot i saw in pictures and have now printed and tried it and it does seem to improve tracking consistency while the paddle is flipped. It drifts if flipped for too long or angled too far where the led just becomes fully obscured by the controller itself, but the window before the tracking drifts is much larger and lenient to many more hand positions from a small bit of testing so far. I dont know a ton about 3d modeling so if sanlaki wants to refine it a bit they may have an easier time than I.