Overview:

I have an AI Dot camera installed by my CNC, and had it mounted above and behind the machine.  This was not optimal when doing 4th axis work as the spindle was always in the way.  I created this mount, so I could move my camera to different viewing angles depending on the project.  I have one mounted with screws above and behind the machine, and another one attached to the MASSO controller using double-sided tape.  I can simply remove the camera from one mount and slide it into another.

The fit is snug, so the camera does not slide out on its own.  

Printing:

Print in nearly any material, but I just used PLA.  If you print in the orientation shown, you may not need supports, but I added them to the sharp corners at the bottom.  This is minimal and adds a little stability.