A hueforge portrait of a penguin. 

Project: Penguin.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

    #080a0d PLA PolyLite Black  Transmission Distance: 0.3
    #4c5f71 PLA BambuLab Basic Blue Gray  Transmission Distance: 3
    #8c9099 PLA PolyLite Grey  Transmission Distance: 1
    #e2dedb PLA PolyLite White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Blue Gray
    At layer #11 (0.96mm) swap to Grey
    At layer #19 (1.6mm) swap to White for the rest.