This is my second attempt at creating a 3D model. I hope someone can improve and optimize it, but functionally, it works very well for my use case.

I made this bracket to point the Linptech ES1 human presence sensor downward, so as to avoid false alarms from ceiling fans in the room.Unlike the previous version, this design allows you to adjust the sensor angle by utilizing the disk holder included with the device. Simply slide the disk firmly into the slot to magnetically attach the sensor, route the Power supply cable through the aperture at the bottom, and then tilt the sensor up/down to the desired position.

Please share your feedback, and I’ll do my best to make updates.

Buy the Linptech ES1 human presence sensor [Amazon]