A doorway diorama for small figurines. A 3.2mm hole is on the left side streetlight for a 3mm led, with a pathway for the wires built in. It is scalable, as I have at less than 50% without much loss in detail. The print in the picture was printed as one print with the robot combined with the model. It was printed at 140 micron (0.14 mm) with 20 degree support on a Zortrax M200 in Cool Grey Z-ABS.

The size is approximately 54.5mm length, 58.6mm width, and 56.5mm height. The diorama was scaled to the robot.

It was modeled in DesignSpark Mechanical.

The robot from the picture is this one without the base:

http://www.thingiverse.com/thing:156371

Dutchmogul's 'House Vermeni Guardian Mech, Advancing'