Summary

BLtouch adjustable for Ender2pro

All models use 3mm screw and nut.

v4
tested and re-tolerance older v3 its should be all loosened fit with good angles as no support is needed.

V3
so made v3 of it on sketchup it should all be good I will update it once it prints out.
its light and fast to print mx 50min with 60mm/s 3 walls 70 infill 5 top and bottom layers

v2
It has a housing for a nut from rear and allows you to adjust without a hassle and no re-assembly needed. good edges Muddled on Shaper 3D. 3 walls 70 infill 5 top and bottom layers have not printed yet!!!

V1
Just printed out and the tolerance is tight, I used a vice to push them together... Bltouch slot is also tight, I will repost with new one asap. overall very rigid and stable body. 3 wall coun 70% infill. overkill but its a durable piece I may make it a little slimmer!!!

just got v4.2.7 board and couldn't find a reliable and printable mount.
this is made for Ender2pro carriage

adjustable
2 part print for strength and material integrity (it won't break easy)
there is an 10mm angle to further protect from heat creap.
slot in and secure in with 3x3mm bolts

I will update once I print and play around with-it.
Please dont judge my 3d modelling as it was Sketchup online as I had no other access at the point. I will re model on shaper 3D asap.