Latch for old digicams with broken battery doors, it should work on any camera that has enough of a shelf for you to superglue the pin to it.

You'll need to measure the size latch you need for your camera, I printed these files at 20% for mine but YMMV

No supports required, print at the smallest layer height you can manage (I did 0.08 in the image but .12 seemed to work fine too.)

• The pin has a base that is superglued to the camera itself.
• The latch goes through the pin and the cap is superglued on the shaft to keep it in place (USE A TOOTHPICK to accurately put down a small amount of glue)
• The spacer is optional, it goes underneath the fingernail part of the latch to hold the battery door flush, it may not be required but my battery door has a negative contact for the battery and I wanted to make sure it was held tight.

Doesn't Matter

No

0.04 - .12

25

Scale according to your camera.