Designed to mount RunCam Swift micro into the BoltRC Kraken pod. It brings the camera forward to compensate for the shorter lens. Uses original M3 side bolts and M2 camera bolts direct into print. Can glue threads if they wear loose.

The longer thicker one of the sides was the best so far.
The box I forgot to cut a hole for the plug but can be cut with a knife, I moved on from this design to the sides

Tarantula

No

No

0.2mm

50%

Ive been printing these on Polymaker Polyflex, a bit firmer than a lot of TPU. Tevo Tarantula with a bowden feed, print slow with acceleration down. 15-20mm/s print speed, no retraction etc.