I found the stock Qidi door handles a bit awkward to use so I designed simple hook type alternative versions. Also due to my setup dimension constraints I created a different filament spool stopper that is shorter.

The handles use same screws that the stock handles are attached with. Two different versions exist for the design: one where the handle is flat with the hook and one with the hook rotated 90 degrees.  I wanted to have differently aligned handles for the top cover and the door.

The filament spool holder stopper uses similar track to lock in place with the spool but does not have a extension to turn the stopper that was too wide for my table.

While I have the Q2C printer, I am under the assumption that the handles are same size in the Qidi Q2 printer so these should fit as alternatives for that also.