Description

Made a new mid section with the original outside dimension from the printhead setup, more or less 20cm outside dimension from the feeder lines.

With this you can simply screw the feeder on a shelf and led the feeder connect to this. the distance feeder dryer will be closer so less needed to put the filament manually instead of the original design.

print 1 part "support 45°" and print the left and right bucket from the original design. In my case the pieces slide just by hand in to eachother. But it is possible that you need tp give it a small sandpaper adjustment.

I printed the part in petg and use 3 walls and 20 %infill just to make it a bit stronger but now it is for me verry stable. In my case i use normal support everywhere, your holes will be nice round and in my case the support whas easy to remove also from the part himself.

I use the feeder bucket from JanzisTechStuff and i use the parts from the file:

V2.0_SnapmakerU1_FeederRelocation_PC4M6_lagerChannel zip

Hope someone can also have fun with this.