Dji Goggles 2 cable clamp

I used an Ender 3 3D printer: Here are the parameters I set in CURA.
TPU print settings for Cura
Layer Height 0.2mm
Line Width 0.4mm
Wall Thickness 0.8mm (2 walls)
Top/Bottom Thickness 0.8mm (2 layers)
Infill Density 10%
Infill Pattern Concentric
Printing Temperature 205°C
Build Plate Temperature 0°C
Print Speed 20mm/s
Enable Retraction Disabled
Combing Mode All
Enable Print Cooling Disabled