If you want to see what else I am making, follow my instagram! @wiseprints206

Like my stuff? you can find more things I've designed at: https://thangs.com/designer/wiseprints

Essentially this is designed to snap around a 3 inch support beam that goes through a false ceiling. The false ceiling in this case was crumbling where the beam entered, and a cap that fit on the beam was needed to cover the mess. This design should fix the issue.

I designed them with inches not millimeters, so when they get put on the build plate, its going to be 6 mm long end to end, rather than 6 inches end to end. just scale it up to inches by sizing it up 2540 percent.

Side note: it made me select lulzbot mini 2 on the printer list before I could publish, I did not print this on a mini 2 and dont know if it will fit on the bed or not.

Lulzbot

Mini 2

No

Yes

20 percent

slap this on the bed with 20 percent infill and supports and you are ready to go.