A kiwi cutter.
I saw on "temu" and i did not want to wait weeks to get it. I made one.
Printed:
Prima Creator PETG,
235C
bed 80C
infill 25%
Wall thickness-2mm
The stainless wire dia. is 1.5mm
To put it together :
Print it, clean it sand it , if necessary
1st. open the holes on "insert piece" (if isnt fit the wire in)
2nd screw it in the body(stl),
bend the wire by wrapping it around a piece of pipe(or anything like that) in my case was a 30-35mm pipe in diameter
when you release it it should be about 45-47 mm
and plug it into place, (try to keep it paralell, because(There are holes in the thread of the inser, but the body has nothing.
So you need to push them through until you reach the bottom.
This will lock the "thread"
if you do everithing right, you going to get a nice kiwi cutter.
Happy printing!!

Artillery

Artillery Sidewinder X2

No

Yes

0.23

25

Make the wall thick.