Hi everyone, today I’m bringing you my work "SENTOR." Feel free to download and print it.

The entire assembly takes about 2 hours and doesn’t require screws or glue.

PLA is recommended for printing, as some parts are quite small, and PLA makes printing and assembly easier. You can freely experiment with color schemes.

A 0.3mm tolerance has been set for part gaps in the original design. Depending on your print results, you can use Blu-Tack to reinforce connections, though there shouldn’t be any issues with assembly.

Blu-Tack isn’t mandatory—you can assemble it without it.

For certain parts, a rubber mallet might be helpful. Refer to the assembly instructions for details.

"SENTOR" is my first attempt at designing a mech, representing a significant challenge. It holds special meaning for me. I hope to share this work with fellow mech enthusiasts, allowing everyone to experience the process from printing to assembly and enjoy the sense of accomplishment upon completion. It was this very sense of achievement that set me on the path to becoming an engineer, so I also hope more people—both young and old—can discover the joy of creation and join the ranks of creators, enriching our lives together.

For a detailed video introduction, check out my social media.

https://www.youtube.com/watch?v=tvkU7OJ_NZI
https://www.youtube.com/watch?v=1V6TTvvLkvM

All STL file wrapped in the ZIP file, if any issue please leave me a message.

Thank you!