This holds a remote control on the handle bars of an exercise bike or other piece of workout equipment that has a 1¼ inch (32 mm) padded handle bar. The remote control is held securely by the base without covering any buttons so it can be used without having to remove it or steady it with your other hand. It effectively becomes part of the controls for the bike while in the holder.

To use this thing you will need the following non-printed items:
1) exercise equipment with a 1¼ inch (32 mm) padded handle bar
2) remote control https://a.co/d/0gg11YhL
3) M3x10 screws (2x)

It is possible that this is compatible with other remote controls also. The one that I used is 45.5 mm wide and 18 mm thick at the base.

The strap is NOT adjustable. It was designed to exactly fit the handle bar for the bike that I have, and it fits VERY tight. A clamp was needed to squeeze it together good enough to make the screw holes line up when installing it.

Recommended print orientation:
Holder - opening for the remote control should be facing up
Strap - on its side (as pictured in the preview)