Project: Cafe-Racer.hfp

When printing with a layer height of 0.08mm and a fill rate of 100%, the height of the base layer is 0.16mm.

The model size is 163.95x200mm.
It is possible to print with a higher layer height at a minimum depth of less than 0.48mm.
The maximum depth is 2.2mm, and the actual depth is 1.2mm.

Consumables used:
PLA PolyLite, black, transmission distance: 0.3
BambuLab PLA Basic, blue-grey. Transmission distance: 3
PLA PolyLite, grey, transmission distance: 1
PLA PolyLite, white, transmission distance: 5

This printer uses four unique consumables.

Replacement instructions:
Starting with black
Switch to blue-gray at the 8th layer
Switch to gray at the 9th layer
Switch to white at the 11th layer