Often times when I work at my table I need a lot of light, but sometimes it is too bright and dazzling. With this print I can make my light bulbs less bright whenever I need it.

This print consists of two parts that you can put around your bulb. The two parts fit perfectly together, there is no need for glue!
Please note that the upper part of the print (IkeaBulbup.stl) has to be rotated by 180 degrees before printing, because it appears upside down in the file.
How to install: Screw your bulb out of its socket and put the upper part of the print over the bulb. Screw the bulb back into its socket and put the other part of the print over the Bulb.
You can also use a smaller bulb, only the socket has to be the same (E 27), otherwise it won't fit..

I would be happy, if you post a make of your finished print.
Have a lot of fun.

Anet a8

Yes

0,2

15

For best printing results use the following settings:
Skirt outlines: 7
Skirt Layers: 3
Skirt offset from part: 0 mm