This is a case for the Camera Module for Raspberry Pi Zero - Wide Angle from Pi Supply, i.e. Pi Supply SKU PIS-1139.

There is a wall mount bracket and a table stand optionally included.

It also looks a bit like a small wine bottle or a wine bottle on skis if using the table stand. It's not going to win a design contest, it's function over form.

Assembly

Required for assembly of case:

• 2x M3x20 screws
• 4x M3 washers
• 2x M3 nuts

Software

I recommend setting up the Raspberry Pi Zero based RTSP (streaming) Camera for lightweight streaming software that will allow you to stream in 1980x1080 at 30fps.

Note when modifying /etc/rc.local that you only need to put the following line before exit 0, as the extra settings in the guide above will flip the image horizontally and vertically and only run at 5fps at a low bit rate:

v4l2rtspserver -W 1920 -H 1080 /dev/video0 &

Print Settings

Tested and printed on an MSLA printer. MSLA prints will require supports for optimal quality.