This is a mount you can use to relocate a light or camera from your handlebars to a fork mount that has water bottle spacing. It mounts using standard water bottle spacing (62-65mm) mounts found on many touring and aventure forks.

I found a few single screw mounts here on Thingiverse but was afraid they might twist/loosen during use. This mount will not allow any radial movement.

I provided two .STLs with different widths, one 35mm, one 45mm. Depending on how wide your accessory or light is you may need to go with a wider width. You can also scale in 1 direction to create custom widths.

Designed in Fusion 360. I normally am an OpenScad or TinkerCad guy but I wanted to make sure this was strong and needed fillet tool to ensure the transitions were as strong as can be.

Anet

A8

No

No

0.1

25%

This is built to print without support, position in your slicer with the flat mounting face on your bed and you will be good to go.