I couldn't for the life of me find an E12 light fitting for the original design so I decided to improvise last minute and Make a design for an LED light strip. The Pillar does not require any adhesion when assembling to be held in place, however if you're moving it alot, it'd be no harm.

When printing the pillar I would recommend rotating it so the notch for the LED wire is at the top, but it's not required. Otherwise I really enjoyed the original print. To print the lithophanes with a larger depth you can just add a 2mm frame around the picture to so it'll slot into the groves on the pillar.

Thanks rune_devros for the original design. The base is only a modification of your base.

Print Settings

Printer:

Mega S

Rafts:

Supports:

No

Resolution:

Infill:

25

Notes:

Category: Decor