This is a VESA 200 bracket to add Hyperion-enabled Raspberry Pi Zero to your TV setup.

Hyperion (https://docs.hyperion-project.org/) adds realtime lighting using individually addressable RGB LED strips.
It requires:

• one Raspberry Pi Zero running the Hyperbian distribution
• HDMI video capture card with loop out (ie. https://www.amazon.com/dp/B08G1BPY77/ref=cm_sw_em_r_mt_dp_GRCCNA8JG4XSYESBN504)
• 5v 15A power supply (ie. https://www.aliexpress.com/item/33004913931.html)
• IP65 Waterproof APA102 RGB led strip (60 leds/meter) (ie. https://www.aliexpress.com/item/33026336855.html)
• USB Type A for PCB (ie. https://www.aliexpress.com/item/32897604780.html)
• JST XH2.54 4pin (ie. https://www.aliexpress.com/item/32954418743.html)
• Barrel-type DC connector for PCV (ie. https://www.aliexpress.com/item/33005175186.html)
• HDMI and usb cables
• Mini relay with 5v coil to power all electronics through the PSU barrel connector (the "Pwr on" USB port can be used to connect a USB port that provides 5v/0v to the relay coil. I use this hack to remotely switch on/off everything using my TV remote)
• 1N4148 as a relay flyback diode

This thing can be printed and used with:

• VESA 75 to 200 & 75 to 100 adapter mounts (https://www.thingiverse.com/thing:4679071)
• MicroSD holder for VESA 200 adapter (https://www.thingiverse.com/thing:4775870)

All parts can be printed using PLA with 3 walls and 0.1mm layer thickness, 15% infill, all nuts and bolts are M4x15. VESA bracket nuts are M6.

Creality

Ender 3

No

Yes

0.1

15