After adding the enclosure to my SV08, mainly to keep dust (and the cat out) when not printing, I didn't have a good place to put the top glass when printing PLA.

I made a lid prop (like I have for my Qidi Plus4) but it didn't seem to let out sufficient heat.

Designed this to allow the front glass to slide under the rear glass when it's not in use.

This requires printing Top Cooling Kit part C and D from the original Sovol design.

I've added two sets of STL files:

1 - SV08 Top Cooling Kit A with rear glass support and SV08 Top Cooling Kit B with rear glass support which are the original Sovol parts with my modifications, and the two original/unmodified Sovol parts (Top Cooling Kit C and Top Cooling Kit D) if you are printing the whole top hat.

2 - SV08 Top Hat Rear Glass support A and SV08 Top Hat Rear Glass support B which are only the parts I added to the Sovol parts. If you already have the Sovol top hat, just print these two items, drill a few holes in the top hat and screw these on (#4 wood screws fit nicely) and you've saved hours and lots of filament.