This mount simplifies mounting the the 5020 blower fan. This clips around the bolt hole of the fan and then provides a single M2 bolt hole parallel to the air flow.

Not only does this design reduce the total weight, but simplifies mounting the fan. The main draw back of most blower fan mounts are they position their holes aligned to the intake. When we are designing using blower fans, typically we care more about where the air is going instead of where it is come from. This design helps designers refocus on the destination of the air.

Although you could use just a single M2 and a tight fitting rectangle to hold the fan in place, using the other bolt hole does provide additional hold.

This makes designing for 5020 fans extremely easy.

Print with the flat side down, no supports.