Tried printing others without success in fitting correctly . e.g. cable not long enough to fit in it's natural 'non extended' state. My cable (Trapped behind the extruder) kept slipping out and the outer shielding being 'sawed' by the belt. (Yes a cable tie would have helped)..but also on a high object print, the bowden tube and cable were jamming under the top frame. So I created the correct size cable link as the others seemed far too large for the job and a matching snap fit clip. (No need to thread the multi-plug through with this type). 23 Links were needed on mine. Had to mark and drill the extra hole out for a self tapping screw on the right hand bracket and fit a small washer in the other side to stop the cable being squashed.
18/01/20 Updated R/H bracket for a better fit.
18/01/20 Added others parts to kit.

ANYCUBIC MEGA

No

Yes

25%