Have an old beer keg layin' around?   They make great tables for recliners!
The design I put together uses very precise measurements.  It uses a 4mm thick table top,   It was precisely measured out to fix like a glove with a caliper down to the thousandths of an inch.  The center has a peg that goes down into the empty Beer Keg and supports it from the center.   The outside of the table top has a 2mm thick edge that touches the beer keg all around on the inside so that it is very strongly and evenly supported on all sides.  I made the table top even with the handle top.
Mine doesnt have it on the photo but,  
I would also recommend making a 5MM Brim (Outside Only) and leaving it on the print.  It would fill the fine gap around the edge of the print nicely.
Very Solid print,  would support 50lbs of weight if needed,   way more than you would ever need for a cheeseburger,  coke and a TV Remote!
Great use for an old beer keg! 
Enjoy!
How to roughly tell if your beer keg will fit or not:.
1>  Measure across the center on the inside of the handles.   See the photos,  Should be 13 5/8inches.
2>  Measure the height straight down on the sides.   See the photos.   Should be 3 inches.
3>  Take core out and measure the hole in the center.  See the photos.  Should be about 1 ¾ inch opening.
 
If you got those as pictured,   Then this Keg topper will fit your keg!

The minimum size bed for this print I believe is 347mm x 347mm.   It is a larger print.  Sorry,  but thats the size of the beer keg top.  Not much I can do!    Mine was printed on a Anycubic Cobra 3 Max with 420 x 420 x 500mm print bed.   There are a lot of larger printers out there!   Go for it!

I also added a 1/6th keg table top (197mm) as an optional download.  So now there are two sizes to choose from!

If you like the print,  Buy me a coffee!
Paypal me at milspecmichael@gmail.com