This model is a remix inspired by the following designs:

FT EMS Snap Fit Mount by Victor Mateus Oliveira https://www.printables.com/model/1001749-ft-ems-snap-fit-mount

FT EMS V2.4 350 V2 by Fizzy (FizzysTech) https://www.printables.com/model/816080-ft-ems-v24-350-v2

What was changed:

• Reinforced structure to increase overall rigidity and durability

• Redesigned geometry to function as a true retrofit solution

• Integrated support for Voron-style heat-set threaded inserts

• Adjusted tolerances for more reliable and repeatable pass-through engagement

• Optimized for installation without disassembling Z-drives or removing the mounting plate

• Tested on both fully printed FT EMS builds and LDO laser-cut FT EMS kits

Print Recommendations: Materials: PETG, ABS, or ASA (ASA/ABS preferred for enclosed builds). Settings: Use standard Voron print settings for structural parts, 4 perimeters, 40–60% infill (honeycomb or gyroid), 0.2 mm layer height.

Install heat-set inserts carefully to ensure proper alignment and strength