The PicoMiteVGA is a small computer based on a Raspberry Pi Pico that runs BASIC and outputs to a VGA display. It's mostly developed via TheBackShed forum: link to PCB and discussion here: TheBackShed.com - PicoMite VGA Edition PCB - release version - Forum

Only the case base, top and blank end panels are included here. My cutouts were too ugly to share. I've included a 2D DXF for you to work out your own layout.

This design is a kinda-sorta Multicomp G738A functional knock-off, except it only has screw holes in the base that are a subset of the real design. I also baked in M3 hardware, while the original prefers M2.5. I used nylon machine screws so I could trim them to length.

If you use the same RTC board I did, you may need to file the print at one post a little to improve the fit.

I printed this in PLA. You may need to include selective support around the nut catches in the top of the case.