A “module”  that goes between the earcups when flat to turn off the AirPods because for some mysterious reason, they don't have a power button and use a bra instead to put to sleep.

The model comes with a space of 9mmx3mm ( +0.2mm ) for the magnets. I used 9x3mm magnets but you could use any magnets with the height of 3mm, up to 9mm diameter.

I used these ( German supplier ) magnets from supermagnete.de. If you want to use your own magnets, make sure the poles point towards the AirPods' sensors as they will be inserted sideways.

For example, the poles here will point towards the AirPods when put into the print, as the magnet will be on its side.

To print, create a pause either 1 layer before it gets printed over, or if your slicer pauses the print on the layer you selected before it starts printing (eg. “Insert a pause command at the beginning of the layer” ), on the same layer.

Then, when your printer pauses, slide the magnet in until it is flush and continue the print.

If you want to use a different magnet which won't fit, shoot me a DM over on discord [ realtonkyt ] and we can figure something out.

Cheers