Pi Camera mount (not official camera)
Tyrone Dawson
Mit KI Ähnliches finden
Druckprofil(0)
Modelldatei(0)
0
0
0
Veröffentlicht:2025-12-08 21:58:55
0
0
000Beschreibung
Modellquelle
Rezensionen(0)
I bought a Pi camera: https://www.ebay.co.uk/itm/Raspberry-Pi-Wide-Angle-Camera-Module-Pi-Zero-Cable-Included/153078067107
However the standard Raspberry Pi camera mounts will not fit this, so I created my own. The camera module slides in and is a tight fit - but this means no screws/glue are needed.
For the bracket, I use the one from here: https://www.thingiverse.com/thing:2886101
The camera stays in place because the two small screws on the back fit into the holes - its a tight fit to get them in there, but means it wont fall out.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Notes:
I use a brim as its best printed with the open end up for better adhesion.
How I Designed This
Rough version
Used a calipers to measure the module that I had - in Fusion 360 just made a clip that would hold it and use the back screws to keep it in place.
Modellquelle
Original-Link: Details anzeigen
CC-BY