A maximum of 6 wired microphones can be installed on a stand. Various Shure, Sennheiser, and AKG microphones have been tested. It is not compatible with larger wireless microphones.

I provided three models: I prefer the HeatInsertThreadAdaptor - it uses a 1/4-20 threaded heat sink and a 5/8-27 to 1/4-20 adapter. The 1420ThreadAdaptor file skips the heat sink and models the 1/4-20 thread, which most modern printers can handle. The DirectThread model doesn't require additional hardware, but it requires a high-quality printer. On my Bambu P1S, I was able to get a sufficient thread with a layer height of 0.12, but it was quite tight. I added a small DirectThreadTest

The hardware I'm using:

www.amazon.ca/dp/B09STSP2VN

www.amazon.ca/dp/B0CZPD55C1

I printed it with PLA material, with a layer height of 0.2mm, a 4-layer wall, and 20% gyroscopic infill and support.