I liked the small design of the original and the first remix making it on the RHS. I just want it to keep an eye on things - its not great for recording timelapses.

I used @Andy_493591's model as a reference in onshape to make my model. I was using it as a learning experience. I started off trying to make a press-fit join for the two parts but ended up just using bolts.

You'll need the following:

• 2 * M3 nuts
• 1 * M3x8 bolt
• 1 * M3x12 (or 16) bolt
• 4 * M2x12 bolts
• 4 x M2 nuts

I already had a set of these from this: https://www.amazon.com.au/dp/B0CJ3GB47W?ref=ppx_yo2ov_dt_b_fed_asin_title

The orientation I used for printing was such that the opposing surfaces of the parts were face down.

Construction is pretty straight forward: The M2s are to fit the camera module while the M3s join the two parts together. I had to heat up the lower nut a bit to fit nicely in the cut out for it.

Here's the onshape document:

https://cad.onshape.com/documents/c16757938fcf32397ff35b04/w/d1854355c11e9cf2e69631c6/e/7911d32569d0917104ba4d6d?renderMode=0&uiState=67cd3f0df769e81b461e8fa9

You can probably see the point where I got bored and it all got a bit messy :)